How to Remove an LG Monitor Stand and Neck (Including the Hinge Stub for VESA)
LG made a very popular line of budget IPS monitors – including the LG 23MP55A, LG 22MP67D, LG 23MP57HQ-P, and dozens of related MP and MK series displays. Putting the stand together takes half a minute: snap the neck in, attach the base plate, and tighten one screw. Taking it back off to pack the monitor into a box or mount it on a VESA arm is another story – pulling straight down by force gets you nowhere.
LG 23MP55A: slim IPS panels do not forgive brute force when removing the stand
Yanking hard is a bad idea – the panel is thin and the plastic clips snap easily. Below is a clean step-by-step guide to removing the base plate, the vertical neck, and the stubborn protruding hinge stub that readers ask about most often when switching to a VESA mount.
Step 1. Remove the Bottom Base Plate
- Unplug all cables. Disconnect power and HDMI/VGA cables, then lay the monitor screen-down on a soft towel or blanket on a flat table so you do not scratch the display.
- Loosen the bottom screw. In the center of the base underside sits a thumbscrew (or a wide slot for a coin or flathead screwdriver). Turn it counter-clockwise all the way and slide the flat base off the vertical neck.
Step 2. Detach the Vertical Stand Neck Without Breaking Clips
On the MP55, MP57, MP67, and similar LG models, the vertical neck locks inside with a spring-loaded internal latch so it cannot slip out while carrying the screen:
- Use the flathead release slot. Look for the small rectangular slot near where the neck meets the lower edge of the monitor. Insert a standard flathead screwdriver and gently press and wiggle the neck up and down without jerking – the internal catch releases and the neck slides out cleanly.
- Check for a rear push-button. Some revisions replace the hidden slot with a flat plastic release tab right above the neck joint: press it inward firmly while sliding the neck straight downward in line with the chassis.
Step 3. Removing the Remaining Hinge Stub for VESA Mounting
A common frustration from readers: the base and neck are off, yet a short metal-and-plastic hinge stub still sticks out of the bottom of the screen. If you are only packing the monitor into its original box, leave it on – the foam insert already has a cutout for it. If you want a flush wall bracket or VESA monitor arm, though, that stub gets in the way.
LG used two designs across these models:
- Clip-in hinge adapter. On certain revisions, the same flathead release slot frees the remaining stub too – gently work the screwdriver inside the slot without prying hard against the outer bezel.
- Bolted from inside the back cover. On many MP55 and MP57 monitors, the metal hinge bracket is screwed directly to the internal frame behind the rear plastic shell. To remove it, slide a plastic pry tool or old credit card along the seam between the front bezel and back cover (starting at the bottom), pop the perimeter clips loose, lift off the rear shell, unscrew the hinge screws, and snap the back cover shut again.
When bolting on a VESA arm (typically 75×75 or 100×100 mm), double-check screw length before tightening – screws that are too long can bottom out against the power board or LCD panel. Once you know where the latch sits, the whole job takes just a couple of minutes with zero brute force.