How to Check If Hardware Virtualization Is Enabled in BIOS on VMware ESXi
Suppose you are troubleshooting a remote server running VMware ESXi where a 64-bit guest VM or nested virtualization refuses to start, and you need to verify whether CPU hardware virtualization (Intel VT-x or AMD-V) is actually enabled in BIOS.
You do not need to reboot a production hypervisor just to peek into BIOS – ESXi can report the exact BIOS virtualization state live in a couple of seconds.
Method 1. Via SSH in the ESXi Shell
Connect to your ESXi host over SSH (enable SSH first in the ESXi Host Client under Host → Actions → Services → Enable Secure Shell) and run:
esxcfg-info | grep "HV Support"
The command prints an HV Support line with a numeric code from 0 to 3:
0– Intel VT-x / AMD-V hardware virtualization is not supported by this hardware.1– VT-x / AMD-V might be supported by the CPU, but is unavailable on this platform.2– the CPU supports hardware virtualization, but it is currently disabled in BIOS (you must enable it in BIOS/UEFI).3– Intel VT-x or AMD-V is enabled in BIOS and ready to use.
In the screenshot above, the output is 3, confirming hardware virtualization is active.
On newer ESXi 7.0 and 8.0 hosts, you can also inspect global CPU hardware virtualization details through esxcli:
esxcli hardware cpu global get
Method 2. Using the ESXi Host Client Web UI (No SSH Needed)
If you prefer not to enable SSH, open the host web interface in your browser (https://your-esxi-ip/ui) and check Host → Manage → Hardware (or the CPU summary box on the main Host page) – hardware virtualization status is listed directly in the processor details.
2: on Intel server and desktop boards, check Processor / CPU Configuration for Intel Virtualization Technology (or Intel VT-x, plus Intel VT-d for PCI passthrough). On AMD EPYC and Ryzen platforms, look for SVM Mode (Secure Virtual Machine) or AMD-V.If ESXi still reports 2 after you enable VT-x in BIOS and perform a warm reboot (Ctrl+Alt+Del), perform a full cold power cycle (power off and back on via IPMI / iLO / iDRAC) – some CPU feature registers only latch virtualization changes after a complete power reset.

