TECH / Hardware 3 min read

One Long Beep and Two Short Beeps – BIOS Signal Meaning and Fix

Antonio NEMCD Author
Published Dec 28, 2012 · 3 min

When a PC powers on with a black screen and the motherboard speaker sounds one long beep followed by two short beeps, the BIOS is almost always reporting a graphics card (video adapter) problem.

One long beep and two short beeps – BIOS video error

In classic Award BIOS and AMI BIOS – as well as most modern ASUS, Gigabyte, MSI, and ASRock UEFI boards – the “1 long + 2 short” POST code means the system failed to initialize the GPU or could not get a response from it.

What to Check First (Step by Step)

Before assuming your graphics card is dead, run through the simple checks below – most of the time the fix takes five minutes:

  1. Cut all power first: shut down the PC, flip the PSU switch off, unplug the power cord, and press the case power button a couple of times to drain residual charge.
  2. Reseat the graphics card: unscrew the bracket, release the PCI-Express latch, pull the card straight out, and push it firmly back in until the latch clicks. Heavy GPUs easily sag or shift slightly over time.
  3. Clean the slot without a household vacuum: blow dust out of the PCIe slot with compressed air or an anti-static brush (never stick a regular vacuum nozzle inside a PC – static electricity can kill components). Gently clean the GPU’s gold edge contacts with a soft white pencil eraser (brushing away all crumbs) or isopropyl alcohol.
  4. Check GPU power cables: make sure all 6-pin, 8-pin, or 12VHPWR cables are seated completely flush on both the graphics card and the modular power supply side.
  5. Verify the monitor and display cable: surprisingly, some modern UEFI motherboards emit “1 long + 2 short” on a cold boot if the monitor is switched off or the HDMI/DisplayPort cable is loose.

If Reseating the GPU Did Not Help

  • Reset CMOS (BIOS): with power unplugged, remove the CR2032 motherboard battery for 2–3 minutes or bridge the CLRTC / JBAT1 jumper. Corrupted PCIe or overclocking settings can prevent GPU initialization.
  • Test integrated graphics: if your CPU has built-in graphics, remove the discrete card and plug the monitor directly into the motherboard video port. If the PC boots cleanly with no beeps, the fault is definitely the graphics card, its power feed, or the PCIe slot.
  • Reseat the RAM: on some older AMI and OEM motherboards, poor RAM contact can produce a similar early POST beep pattern. Try booting with a single stick of memory.
  • Check EZ Debug LEDs: if your case has no piezo speaker, modern boards light up a dedicated VGA diagnostic LED near the 24-pin connector – it signals the exact same error.
BIOS vendor differences: on Award BIOS, “1 long + 2 short” always points to the video adapter. On AMI BIOS, video failures are also commonly “1 long + 3 short” (while “1 long + 2 short” flags video initialization or checksum issues), and laptop Phoenix BIOS uses four-part beep sequences such as 1-2-2-3.

If the GPU stays silent even in a second PCIe slot or another working PC while the power supply is known good, it is likely a hardware failure on the card itself (power stage, VRAM, or GPU solder joints). Still, always start with reseating the card and power connectors – in everyday troubleshooting, that solves the majority of cases.

Related posts:

Leave a Comment